Uneven Gravure Printing Layers and Causes

Dec 04, 2023 Leave a message

Uneven Gravure Printing Layers and Causes

Unevenness in gravure printing layers can be categorized into uneven gradient layer printing and uneven shallow layer printing.

Uneven gradient layer printing is primarily due to the unavoidable occurrence of dot overlap areas, regardless of the engraving technique chosen during the plate-making process. Although it is possible to adjust the ink viscosity during printing to alter the areas with dot overlap, it is impossible to prevent the occurrence of dot overlap. Therefore, controlling unevenness in gradient layer printing during production is challenging. It is advisable to alleviate peculiar printing unevenness caused by dot overlap by selecting a better engraving technique during plate-making.

Uneven shallow layer printing is mainly caused by the following reasons:

Excessive Ink Viscosity or Rapid Solvent Evaporation:

Uneven groups of thread-like patterns result from high ink viscosity or excessively fast solvent evaporation during the printing process.

Low Ink Viscosity:

Uneven flower-like patterns occur in the layer during the stacking process due to low ink viscosity, leading to uneven printing.

Rough Printing Plate Cylinder:

Roughly made printing plate cylinders with burrs cause uneven scraping during the printing process.

To address uneven shallow layer printing, the following measures can be taken:

Adjust Solvent Evaporation Speed:

Reduce solvent evaporation speed appropriately and increase the use of slow-drying solvents.

Control Printing Workshop Temperature:

Adjust the temperature in the printing workshop by either increasing or decreasing it.

Select High-Quality Ink and Printing Plate Cylinder:

Choose ink and printing plate cylinders of better quality to mitigate unevenness in shallow layer printing.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry