Please pay attention for these 4 points when using two-component polyurethane adhesive to composite paper and plastic!

Jul 15, 2020 Leave a message

Please pay attention for these 4 points when using two-component polyurethane adhesive to composite paper and plastic!

001


It is said that paper plastic composite is easier than plastic plastic composite. However, when two-component polyurethane adhesive is used in paper-plastic composite, improper use often leads to some quality problems, such as poor peel strength, blistering at the heat seal, curling, etc. The causes of quality problems are mostly mutual influence, such as blistering at the heat seal, poor peel strength, wrinkle and so on.


1,Two component polyurethane adhesive is a reactive adhesive, and it is very sensitive to the content of water and alcohol in the solvent. At the same time, because the composite paper also has a certain amount of moisture, these will affect the full bonding of polyurethane adhesive. Therefore, great attention should be paid to compound.


2、The surface of paper is rough and there are many pores. Compared with plastic plastic composite, the amount of glue is large, otherwise it will affect the composite strength or produce bubbles.


3、Humidity of composite paper. If the humidity is too high, the composite film will bubble. There is a soft packaging manufacturer manufactures areca paper packaging bags with OPP printing / paper / PE. The composite product is impeccable in appearance and peel strength, but bubbles are found in the heat seal during bag making.


This phenomenon appears in the middle of the hot knife position, and the two sides of the heat seal place there is no bubble. The bag making process of forming two packaging bags at one time is adopted. The ironing knife on both sides is narrow, and the ironing knife in the middle is wide. After heat sealing, the two packaging bags are cut by the blade.

 

Bubbles are produced in the middle of the wider heat seal, the heat seal on both sides of the bubble will not appear. Later, through adjustment, in the process of bag making, the composite film is first cut with a blade between the two packaging bags, and then through heat sealing, the bubble phenomenon disappears.

 

Due to the high moisture content of the paper, the water vapor expands during the heat sealing, and the water vapor at the narrower heat sealing place on both sides can run out of the incision, while the water vapor can only generate bubbles in the middle because there is no incision.

 

4, As polyurethane adhesive is a reactive two-component adhesive, its relative initial adhesion is poor when it is used to composite paper. After the plastic film is glued, the temperature of drying path should not be too high, the tension should not be too large, and the temperature of composite roller should not be too high, otherwise the phenomenon of curling or wrinkling will occur easily.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry