How to Distinguish Hickeys and Smearing in Gravure Printing

Dec 14, 2023 Leave a message

Different Manifestations:

Dragging starts gradually from a certain part of the graphics and fades away, resembling an animal tail, often referred to as "dragging."

Smearing, on the other hand, occurs at the edge of the graphics, overflowing with a shape similar to the graphics width, with lighter ink density and an irregular shape.

Different Causes:

Dragging is caused by impurities between the doctor blade and the printing plate, extending to the back of the blade. When the blade scrapes the graphic part of the plate, impurities come into contact with the ink. As the blade scrapes away from the graphic part, the impurities lag behind the blade, contacting the plate and causing the graphics to drag.

Smearing is mainly due to the curved contact between the doctor blade and the plate. When the blade scrapes the graphic part, the blade, under prolonged pressure, tends to straighten. When the blade moves away from the graphic part, the blade hits the mesh shoulder, causing a rebound. This results in incomplete scraping of the plate, and under printing pressure, ink overflows, causing smearing.

Different Solutions:

To resolve dragging issues, a gentle scrape with a bamboo stick is often sufficient.

Resolving smearing issues requires adjusting the blade and reducing air pressure.

Commonalities in Both Issues:

Both dragging and smearing issues are more likely to occur when ink viscosity is low. Therefore, increasing ink viscosity appropriately can prevent both issues.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry