Blocked Screen
Foreign substances (such as curing agents or dried ink) blocking the dots on the printing plate can lead to poor ink transfer within the dots during printing. This results in an uneven, unclear, or incomplete print, deviating from the intended uniform and clear image.
Abnormal Causes:
Extended shutdown leading to ink drying and hardening on the plate surface.
Impurities or foreign objects (paper dust, ink skins, ink clots) in the ink blocking the dots on the plate. Commonly, residue ink or curing agents from the previous batch, not thoroughly washed off, causes blockage.
Insufficient depth of printing dots.
Incorrect use of solvents.
Incorrect use of ink.
Significant airflow around the printing press (e.g., accidental opening of the exhaust door panel of a Rodelmaier press, causing premature drying of ink in the dots).
Limitations in the printing process (certain special orders requiring high viscosity ink for specific colors, making it prone to blocking).
Countermeasures:
Wipe the plate with a nano-sponge soaked in solvent. Note: Avoid using a cloth dipped in dust to clean the plate during normal production to prevent uneven ink removal, which can lead to customer complaints.
Use a steel brush dipped in wash solution to clean during shutdown, which effectively removes ink residues or foreign substances from the plate.
Redo the plate, increasing the dot depth.
Shutdown, clean the ink fountain, and remix the ink.
Shutdown, clean the ink fountain, and replace the ink. Clean the dots on the plate if necessary.
Close the cover or use a film to reduce external airflows.
Use an ink guide roller to ink the plate. (An active guide roller is preferable, but a passive one can also be used.)
Ink Deficiency
Localized absence of ink transfer in the printed graphics can occur in three main situations:
Large areas with variable shapes lacking ink horizontally and vertically due to insufficient ink.
Small areas with fixed horizontal positions, variable vertical positions, and similar shapes lacking ink due to abnormal impression cylinders or doctor blade holders.
Small areas with fixed horizontal and vertical positions and identical shapes lacking ink due to plate abnormalities.
In a rare situation, minute water or oil leaks from the equipment, accidentally dripping onto the plate, result in incomplete ink transfer, manifesting as fixed horizontal and vertical positions with similar shapes, but the range gradually decreases.
Abnormal Causes:
Insufficient ink quantity in the ink fountain.
Large ink amount with a small ink flow at the ink pump outlet.
Too little ink in the ink bucket, causing the ink pump to be unable to supply ink.
The ink fountain descends during production, leading to insufficient ink levels.
Improper ink fountain height.
Too low: The ink in the fountain is insufficient to cover all graphics on the plate.
Too high: The ink fountain or sediment in the ink fountain scratches the graphics on the plate, removing some ink.
Doctor blade holder's paper guide is too long, curls, and touches the graphics on the plate.
Foreign substances (e.g., insects, dried ink clots) adhering to the impression cylinder.
Slight depressions or pits on the impression cylinder.
Poor roundness of the impression cylinder.
Defects in plate dot engraving (missing dots).
Abnormal protrusions on the plate surface (removal of ink in some raised dot areas due to doctor blade scraping).
External water or oil drops on the plate.
Countermeasures:
Ensure an adequate amount of ink in the ink fountain.
Increase the ink pump's capacity to enhance ink output.
Regularly check and promptly add ink when insufficient.
Adjust the ink fountain height appropriately (maintain ink immersion in the plate at about 1-2 cm).
Shorten the rear paper guide appropriately to prevent curling or reduce the ink fountain height.
Remove foreign objects from the impression cylinder.
Increase printing pressure appropriately (ensuring the impression cylinder presses the dots in the plate's depressed areas).
Replace the impression cylinder with better roundness.
Redo the plate.
Reduce doctor blade pressure and increase impression cylinder pressure (ensuring ink transfer in areas with raised plate dots).
Prevent external water and oil drops, avoiding splashes onto the plate.





